HDSDR is not working.
Displaying 1-2 of 2
| Feb 15th 2018, 18:43 | |
N1AUPTotal Topics: 0 Total Posts: 0 |
I purchased an RTLSDR box off of Ebay, to use as a PAN adapter for a Kenwood TS590SG. https://www.ebay.com/itm/US-100KHz-1-7GHz-Full-Band-U-VHF-RTL-SDR-USB-Tuner-Receiver-R820T-8232-Radio/131452779473?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649 When I run HDSDR, I don't see any signals showing up on the PC screen. Here is what I've done so far. I confirmed the Kenwood is putting signal out on the DRV port, by patching same into the SO239 on a second receiver. I connected the SDR to the PC, installed the Zadig drivers, Omnirig, and HDSDR. SDRSharp works. I see signals, and hear audio that matches what is coming in on the Kenwood if I manually sync the two. HDSDR talks to the Kenwood just fine. Changes frequency and mode. When I run HDSDR though, I see no signals on the screen, and hear no audio coming out. I'm betting that I have the software set up wrong, but after hacking around for four weeks, I'm no closer to finding a solution. Is there someone who is intimately familiar with HDSDR who can talk me through settings to find out where I'm messing up? I'd love to get it working so I can see signals on the various bands. Thanks |
| Feb 26th 2018, 05:29 | |
N1AUPTotal Topics: 0 Total Posts: 0 |
Problem solved. I found the entry "Options / Misc Options / Reset to factory settings". That fixed whatever was not set right in the software. |
Displaying 1-2 of 2
